Silicone Remote Cover / *Case 

This is a VIPER cover that can fit* these CLIFFORD Remote Control Transmitters:

*DOES NOT replace the hard, underlying case - it is an outer, protective cover for that case

479X

489X

7341X

7701X

Choose from 6 Colors! 

Soft Silicone Case ONLY - Remote is not included

PROTECT your valuable remote and extend it's life, and look good at the same time!

*PLEASE READ: This silicone cover is made for VIPER, not CLIFFORD Remotes.  However, the outer dimensions and the button layout is the same, and the placement of the screen is likewise the same. The contours between the screen and the buttons are a little different.  See bottom of page for additional information

Although not shown in this illustration, you key ring is retained with this silicone case.  The clip can no longer be used.

View of the empty silicone case from the bottom

View of the empty silicone case from the back

View of the empty silicone case from the top

It is easier to insert the remote through the large hole in the case as shown, and then pull the top of the case over the antenna part, although you can also insert the remote through the hole in the bottom.

CLIFFORD Systems That Came with 479X Remotes:

Matrix RSX1.5, Matrix 2.5X, Matrix RSX3.5

CLIFFORD Systems That Came with 489X and 489XD Remotes:

Matrix 10.5, Matrix 12.5X

CLIFFORD Systems That Came with 7341X Remotes:

Matrix 1x

CLIFFORD Systems That Came with 7701X Remotes 

Matrix 20.5X, Matrix 50.5X

*If you want a PERFECT fit on your remote with our silicone case for VIPER, you can replace the hard case on your remote with a hard Viper shell. (See Image)

The circuit board, battery & antenna of your Clifford remote will fit inside this Viper replacement case.  To see this replacement case on Ebay, type "Viper 879 Replacement Case" in your Ebay search box.